When using the FTP client function, error appears on startup.

Q: When using the FTP client function, if the power cuts out during recording start and I turn the power back on, the message, "E657 Ethernet cable is not connected" or "E691 IP address is not set or FTP function is not available" appears. What should I do?

A: Depending on the response speed such as hub or router connected to the main unit, it may take time before the Ethernet Link is established. Therefore, the error message will appear if the FTP transfer is performed before the Ethernet Link is established.
However, even if an error occurs, the data is not lost, and the data will be re-sent at the FTP send cycle. Therefore, you can just use the recorder continuously.
To keep error from occurring, under "FTP client settings" set "Transfer wait time" to 1 minute or more.