Introduction
A battery room is used to storage batteries for emergency power management in the plant. Each substation has battery room and the storage batteries are lead-acid batteries which must be maintained within specified operating temperature limits. Temperature management is important to ensure a long service life of the batteries especially for the plant in desert climates.
Benefits
- Improved maintenance efficiency of storage batteries
- Minimized installation cost, a single hop up to 5km minimized wireless infrastructures (extra repeaters)
- Reduced system maintenance effort, battery life of 10 years with 30sec updates can be realized
- Improved system availability, the gateway redundancy with one second switch over time can be realized
- Improved future installation flexibility and usability, Backbone routers with Sky Mesh Method minimize infrastructure while maintaining high network reliability with low communication error rate
Requirements
- To gather temperature and A/C measurements of each battery room and to monitor them in central control room
- All wireless transmitters to have redundant paths
- Host interface must be compatible with existing 3rd party DCS
- Minimize cost by reduced wireless infrastructure
Solution
Redundant gateways and access points were installed in a central control room. The wireless network has the availability to communicate with 24 battery rooms, over an area approximately 2 km2. In each battery room, an RTD sensor was installed for temperature monitoring and a mechanical flow switch was installed for A/C monitoring. Field and network redundancy ensured high availability of data. An OPC server with an open interface allowed for connecting to 3rd party DCS without any additional software.
Conclusion
Battery rooms are now under wireless monitoring. The redundant wireless system provides reliable network communication over 2 km2 area and cost savings were realized at over 75%. The emergency power monitoring system ensures that power is always available during a site safety event.
Related Products & Solutions
-
YFGW410 Field Wireless Management Station
YFGW410 Field Wireless Management Station has system manager/security manager/gateway function based on ISA100.11a, and combining this with Field Wireless Access Point(YFGW510) and/or Field Wireless Media Converter(YFGW610) composes the field wireless system.
-
YFGW510 Field Wireless Access Point
YFGW510 Field Wireless Access Poin has backbone router function based on ISA, and combining this with Field Wireless Management Station (YFGW410) and/or Field Wireless Media Converter (YFGW610) composes the field wireless system.
-
YFGW520 Field Wireless Access Point
YFGW520 Field Wireless Access Poin has backbone router function based on ISA, and combining this with Field Wireless Management Station (YFGW410) and/or Field Wireless Media Converter (YFGW610) composes the field wireless system.
-
YTA510 Wireless Temperature Transmitter
The high performance temperature transmitter YTA510 accepts Thermocouple, RTD, ohms or DC mill volt inputs. The transmitters transmit not only process variables but also the setting parameters using wireless signal. The transmitters run on internal batteries, and the installation cost can be decreased since hard-wiring is not required. The communication is based on ISA100.11a protocol specifications.
-
YTMX580 Multi-Input Temperature Transmitter
YTMX580 can accept inputs from up to 8 points of measurement such as thermocouples (8 types: K, E, J, etc.) or RTD signals (3 types: Pt100, etc.), converting the corresponding measurement input values to a wireless signal. It can also accept DC voltage, resistance, and 4 to 20 mA DC signal input.
-
Field Wireless
The flexibility of wireless solutions enables less investment in infrastructure while providing greater insights into plant operations.